While travelling charging of mobile battery is great problem because power supply source is not generally accessible. Here is a simple project using very common electronics components for charging mobile battery using AA cells.
The main part of the circuit mobile cellphone charger is timer IC NE555, used to charge and monitor the voltage level. IC1 get control voltage to pin 5 by zener diode ZD1. Threshold pin 6 and trigger pin 2 is supplied with a voltage set by VR1 and VR2 respectively. The trigger pin 2 of IC1 is below 1/3VCC when discharge battery is connected to the circuit as a result flip-flop of IC1 is switched on to take output pin 3 high. The process is reversed when battery is fully charged of charged battery is connected. Here transistor T1 used to enhance the charging current from output pin 3 of IC1. Adjust potentiometer VR1 and VR2 as per require.
Resistors (all ¼-watt, ± 5% Carbon)
R1 = 390 Ω
R2 = 680 Ω
R3 = 39 Ω/1W
R4 = 27 KΩ
R5 = 47 KΩ
R6 = 3.3 KΩ
R7 = 100 Ω/1W
VR1, VR2 = 20 KΩ
Capacitors
C1 = 0.001 µF (ceramic disc)
C2 = 0.01 µF (ceramic disc)
C3 = 4.7 µF/25V (Electrolytic )
Semiconductors
IC1 = NE555 timer IC
T1 = SL100 or any Medium power general purpose NPN transistor like: 2N4922 , 2N4921,2N4238, FCX1053A
ZD1 = 5.6 V/1W
LED1
Miscellaneous
SW1 = On/off switch
1.5V*8 AA cells
Mobile connector
No comments:
Post a Comment